NEC UNIVERGE SV9300 Networking Manual page 90

Programming
• For BLF message sending office (Office A)
START
CMA8 Assign a Destination Point Code of each office
within the CCIS network, to the CCH number.
CMA7 Provide Busy Lamp Field (BLF)-CCIS to each
CCH number.
CM12 Specify the sending BLF message via CCIS for
each station.
A maximum of 8 destinations (Destination No.
0-7) can be set for each station.
CM50 Register the DPCs and their destination num-
ber for sending BLF message via CCIS.
A maximum of 8 destinations (Destination No.
0-7) can be set per system.
When the CCIS network adopts Open Num-
bering system, assign the access code and of-
fice number of own office to be added to the
station number for sending the BLF message.
CM08 Specify whether the busy indication is provid-
ed on station base or extension base when the
Sub Line or Trunk Line is used on the
line Terminal
NOTE:
CM08>269
0
1
END
DESCRIPTION
.
The BLF indication is as follows:
When Sub Line When Trunk
is used Line is used
My Line and Sub My Line
Line
Sub Line Not provided
• Y=0
(1) 00001-16367: DPC
(2) 00-63: CCH No.
• Y=30
(1) 00-63: CCH No.
(2) 0: To provide
• Y=30-37 Destination No. 0-7
(1) X-XXXXXXXX: Station No.
(2) 0 : To send
1 : Not sent
• Y=08
(1) 0-7: Destination No. 0-7
assigned by CM12 Y=30-37
(2) 00001-16367: DPC
• Y=07
(1) 0
(2) X-XXXX: Access Code + Originating Of-
X: 0-9, A (*), B (#)
NOTE:
(1) 269
(2) 0 : Station base
Multi-
1 : Extension base
1-76
Chapter 1 CCIS FEATURES
BUSY LAMP FIELD (BLF)-CCIS
DATA
fice No.
Amount of Access Code + Office
No. + Station No. must be no
more than 8 digits.
NWA-088654-001 Rev.1.0
94ch1003.fm