NEC UNIVERGE SV9300 Networking Manual page 293

E
CMA7 Assign a Destination Point Code (DPC) to
each CCH number.
NOTE 1:
The Destination Point Code (DPC)
is used to designate a terminating
office in the No. 7 CCIS network.
Usually a different DPC is assigned
to each CCH number in the same
system.
NOTE 2: For this DPC, assign an arbitrary
value which is different from a value
set by CMA7 Y=01.
Assign the originating office number to each
CCH number, if required.
CMA9 Assign the trunk number assigned by CM10
Y=00 to each D channel number for providing
D channel path between PRT.
CM13 Specify the function of Analog Data station
(Single-Line Station with FAX or MODEM).
NOTE 1:
This command is used to specify the information transfer capability of bearer capability.
NOTE 2:
When the second data is set to 0 (3.1 kHz audio), the following limitations are applied.
- Periodic Time Indication tones are not given to the line.
- Override by other stations is restricted.
- Ringing interval depends on as follows.
The ringing interval for the FAX station is as per the setting of ringing signal for FAX
(CM04 Y=00>09) (default: as per CM04 Y=00>05).
- Call Waiting Answer-Called Side is to be restricted by CM15 Y=44: 0.
NOTE 3: For tandem connection, the information transfer capability is fixed to 3.1 kHz audio.
END
DESCRIPTION
BLADE RESET
• Y=02
(1) 00-63: CCH No.
(2) 00001-16367: Destination Point Code
• Y=06
(1) 00-63: CCH No.
(2) 0000-9999: Originating Office No.
• Y=00
(1) 00-31: D channel No.
(2) 000-511: Trunk No. assigned by CM10
• Y=07
(1) X-XXXXXXXX: Station No.
(2) 0 : Data station (3.1 kHz audio)
1 : Ordinary station (voice)
2-17
Chapter 2 Q-SIG FEATURES
PRT ASSIGNMENT
DATA
Y=00
NWA-088654-001 Rev.1.0
94ch2001.fm