NEC UNIVERGE SV9300 Networking Manual page 325

• If only an IP Station user moves to a visitor unit without doing the logout operation, the user can log
into a visitor unit in which the second data of CM08>516 is set to 0 (To override). If the second data
is set to 1 (Not overridden), "Double Assignment" is displayed, and login to the visitor unit is re-
stricted.
• If you set Call Forwarding-Logout when moving to another unit, calls can be forwarded to the des-
tination (station/outside party/Attendant Console). However, if only an IP Station user moves to the
visitor unit, you must do the logout operation to enable Call Forwarding-Logout.
For Call Forwarding-Logout, refer to "Call Forwarding-Logout (IP Station)" in the System Manual.
The table below shows the call forwarding available/unavailable when moving to another unit ac-
cording to the IP Station moving condition.
IP Station
Moving Condition
Moving to Visitor Unit
Logging in at Visitor Unit
Logged in at Visitor Unit
Moving to Home Unit
Logging in at Home Unit
Logged in at Home Unit
NOTE:
By setting CM15 Y=481, you can select ROT sending, RBT sending, or forwarding to
Voice Response System.
• For the visitor station in the visitor unit, the location number set by CM0B Y=1XX>10 is effective,
even if the location number has been set by CM12 Y=39/50.
• For the visitor station in the visitor unit, the tenant number set by CM0B Y=1XX>11 is effective,
even if the tenant number has been set by CM12 Y=04.
• After moving to a Remote Unit, the IP Station operates according to the conditions of the Remote
Unit.
• The last number redial and stack dial data of IP Station is lost when moving to another unit.
• If only an IP Station user moves to a visitor unit, you cannot use this service with setting of Line/
Trunk Feature Key (number of keys originally provided with IP Station, and data setting of 16/24
Line/Trunk Feature keys) differing between the home unit and visitor unit.
For example, if you use D
Touch keys) at the home unit, you cannot use Soft Phone (24 Line/Trunk Feature keys + 8 One Touch
keys) at a visitor unit.
When the Destination of Call
Forwarding-Logout is set
Available
Available
Unavailable
Available
Available
Unavailable
term
85 (Series i) with IP adapter (16 Line/Trunk Feature keys + 16 One
3-13
Chapter 3 REMOTE UNIT OVER IP FEATURES
Call Forwarding
When the Destination of Call
Forwarding-Logout is not set
Depends on CM15 Y=481
Depends on CM15 Y=481
Depends on CM15 Y=481
Depends on CM15 Y=481
SYSTEM CONDITIONS
NOTE
NOTE
NOTE
NOTE
NWA-088654-001 Rev.1.0
94ch3001.fm