NEC UNIVERGE SV9300 Networking Manual page 256

Hardware Required
To provide the External TAS Indicator:
- PGD(2)-U10 ADP/External Relay Interface on CPU
- Indicator
Requirement to External Indicator
Control Method: Loop/Ground/Battery (-27 V) (Maximum 125 mA)
Type
For cross connection of the TAS indicator, refer to the System Hardware Manual.
To provide the telephone set for TAS Indication:
- GCD-4LCF/GCD-8LCF blade (Two telephone sets per blade can be equipped.)
- Conventional telephone sets
Operating Procedure
To answer an incoming call in Night mode:
1. The TAS signal (bell, buzzer, etc.) sounds indicate an incoming call.
2. Lift the handset and receive dial tone.
3. Dial the TAS access code.
4. Connect to the incoming call.
: Visual and/or Audible type with volume control
TRUNK ANSWER FROM ANY STATION-CCIS
1-242
Chapter 1 CCIS FEATURES
NWA-088654-001 Rev.1.0
94ch1006.fm