Optional Condition Setting Mode - Daikin LXE10E-A Service Manual

https://daikin-p.ru

12. OPTIONAL CONDITION SETTING MODE

Key operation to enter/exit
<
Power OFF
Circuit Breaker ON
Unit OFF
I/O ON
All indication
lights on
(for 3 sec.)
for 3 sec.
Starting
F. PTI
preparation
S. PTI
(for 18 sec.)
M. CHECK
※ 1
Current
indication
(Operation state)
<Key operation in this mode>
Whenever the S key is pressed, the indication changes.
Turn the power breaker OFF after the setting.
d EG C/F
S
CHARTLESS CODE
INDICATION
SETTING
S
S USDA SENSOR
1/2 SELECTION
SETTING
S
H001
S
>
(
I/O
I/O OFF
for 3 sec.
※ 10
Optional
Function
Setting
With dEG C/F mode, can be selected.
Select "C" or "F" on the LED when the LCD displays "d EG C/F".
Whenever the or key is pressed, the indication of the selection "C" or "F".
changes. Press the key to determine the selection. "C" stands for ˚C/kPa while "F" for ˚F/PSI.
To set the chartless code (D code /H code):
Select "ON" (indication of D/H code) or "OFF" (no indication of D/H code) on
the LED when the LCD displays "CHARTLS".
Whenever the or
changed.Press the
To set the USDA sensor selection:
Select "1" or "2" on the LED when the LCD displays "USdA1/2".
Whenever the or
Press the key to determine the setting.(see mode detail→5-4)
H001 code is displayed when the control temperature does not lower by 3 ˚C
or more for every 4 hours in pull-down operation.
Select "1" ˚C ,"2" ˚C ,"3" ˚C ,"4" ˚C ,"5" ˚C or "10" ˚C on the LED when the LCD
displays "H001".
Whenever the or
"1"˚C to "10" ˚C changes. Press the
Refer to page 3-65.
3-29
Circuit Breaker OFF
after setting change
OFF when no setting changed)
for 3 sec.
※ 11
Basic Function
Setting
key is pressed, the indication of "ON" or "OFF" is
key to determine the setting.
key is pressed, the indication of "1" or "2" is changed.
key is pressed, the indication of the selection from
key to determine the setting.
for 3 sec.
※ 12
Optional
Condition
Setting