FujiFilm PB-30 Operation Manual page 39

(4) Press the toggle switch 1 once again.
Make sure that the inside light lights up and the balloon
deflates.
(5) Put the end of the over-tube into water. Press the toggle
switch 1 to inflate the balloon by supplying air. Make
sure that there is no air leakage by putting the end of the
over-tube into water.
After confirmation, press the toggle switch 1 to deflate the
balloon by discharging air.
(6) Attach the over-tube to the endoscope. Attach the balloon
to the tip of the endoscope.
For details on how to attach the over-tube and balloon,
refer to the operation manual of the endoscope.
(7) Press the toggle switch of the remote switch 2 in a similar
manner.
Make sure that the outside light lights up and the balloon
on the endoscope inflates.
Chapter 6 Preparation and Inspection
39