FujiFilm PB-30 Operation Manual page 14

Chapter 3 Name and Function of Each Part
Tube connector 2 (Endoscope side)
4
Tube connector 1 (Over-tube side)
5
Balloon switch 1 (White: Over-tube side)
6
Stop switch
7
Pressure display
8
14
The tube 2 is connected to this part through the filter of the tube kit.
The tube 1 is connected to this part through the filter of the tube kit.
This switch is used to start/stop supplying air to or discharging air from the balloon on the
over-tube side.
When this switch is pressed while the green light is off, the light turns on and air discharge
starts. To start air supply, use the remote switch.
When this switch is pressed while the green light is on, the light turns off and air supply or
discharge stops.
While the buzzer is sounding, if you press this switch, the buzzer stops sounding.
The pressure value or pressure indicator is displayed with LEDs.