Wire And Cable Routing; Activating The Handheld Remote - MotorGuide Xi3-70 SW GPS Operation, Maintenance & Installation Manual

PRODUCT INSTALLATION, WIRING, AND BATTERY
5. Starting with the positive (+) lead, reconnect the battery cables to the
engine starting or accessory battery.
Battery A
24-volt battery connection
a - Power cables to trolling motor
b - Manual reset circuit breaker
c - Jumper wire (not supplied)
d - Negative (–) battery terminal

Wire and Cable Routing

• Route the trolling motor wires on the opposite side of the boat from other
boat wiring.
• The trolling motor should be connected to its own dedicated battery.
• Sensitive electronics, such as depth finders, must be connected to a
separate battery.
• Marine engines should have their own dedicated starting battery.

Activating the Handheld Remote

1. If the trolling motor power cables are connected, disconnect the power
cables from the trolling motor battery, starting with the negative (–) lead.
2. Deploy the motor, then connect the power cables to the battery or plug in
the power cable to a battery source. Within ten seconds of connecting the
power cables, press and hold the left and right arrow buttons on the
handheld remote simultaneously.
eng
INFORMATION
d
c
Battery B
BLACK
c
b
15
a
37824