Table of Contents
Advertisement
7.2.4 Mapping Alarms to Relays
1. Connect a computer to the controller. Refer to the controller software manual. The 48Vdc power must be
switched on before the controller can operate. Provide either DC power on the main DC1 connections or
switch on at least one rectifier.
2. Go to Power System > Inverter System > Configure System.
3. From the Alarms table, select the alarm required and then click the edit button make changes.
4. Select the desired relay.
5. After changes have been made, click Save.
6. Hook up control wires to the selected relay.
0260080-J0 Rev D
69
Advertisement
Table of Contents
Need help?
Do you have a question about the AMPS HP2 Power System and is the answer not in the manual?
Questions and answers