Table of Contents
Advertisement
5.3 System Installation
The AMPS HP2 system is pre-configured from the factory for a single AC feed per phase for inverters, and a
maintenance bypass switch.
The installer is responsible for connecting the following:
•
Utility input to the system (120V line to neutral)
•
Battery strings
•
System to the load
•
Chassis and battery return to the reference ground
Reference Notes:
•
Connections and components relating to L3 are only present for 120/208 V, 3-phase systems.
•
Connections and components relating to L2 are only present for 120/240 V split phase and 120/208 V
3-phase systems.
50
0260080-J0 Rev D
Advertisement
Table of Contents
Need help?
Do you have a question about the AMPS HP2 Power System and is the answer not in the manual?