Default Settings - Digi 6350-SR User Manual

Initial setup
Once the snr_bars and rsrp_bars are determined, use the lesser of the two. That is the reported
signal strength bars.
3G algorithm
Determine RSSI signal strength.
RSSI > -80, bars=5
-90 < RSSI <= -80, bars=4
-100 < RSSI <= -90, bars=3
-106 < RSSI <= -100, bars=2
RSSI <= -106, if we're connected to the cellular network, bars=1, if not bars=0
bars is then reported as the signal strength bars.
2G algorithm
Determine RSSI signal strength.
RSSI > -80, bars=5
-89 < RSSI <= -80, bars=4
-98 < RSSI <= -89, bars=3
-104 < RSSI <= -98, bars=2
RSSI <= -104, if we're connected to the cellular network, bars=1, if not bars=0
bars is then reported as the signal strength bars.

Default settings

Option
Interface priorities
Modem configuration
Network settings
Wi-Fi
WAN failover
conditions
Security policies
Digi 6350-SR/6355-SR LTE Router User Guide

Default settings

WAN set at a metric of 1
n
Note This metric sets the WAN port as the SR's primary network
connection.
Modem (cellular) at a metric of 3
n
SIM Failover after 5 attempts
n
Carrier Smart Select enabled
n
LAN subnet of 192.168.2.1/24
n
DHCP enabled
n
Source NAT enabled (outbound traffic)
n
SSID = Accelerated 6350-SR
n
Password = Accelerated!
n
Channel = Automatic
n
Connectivity monitoring enabled for WAN
n
HTTP and Ping test: 4 attempts set at a 30s interval
n
Packet Filtering set to block all inbound traffic
n
SSH, Web Admin, and Local GUI access enabled
n
Default settings
21