Getting started with aView
Using remote commands
The aView management portal maintains a connection to all online client devices registered with the
service. Using this tunnel, network administrators can send a specific set of remote commands that
will be received immediately as opposed to waiting to check in and apply any changes propagated
from the cloud. The following remote commands are available:
Check Status
n
Check Signal Strength
n
Perform Speed Test
n
ARPing Attached Device
n
Send Wake-on-LAN to Attached Device
n
Check Configuration
n
Reboot
n
Remote commands must be sent to each device separately.
1. Log into the aView management portal and use the search bar to filter devices by MAC
address.
Note
The device MAC address is on its bottom label.
2. Click the MAC address of your Digi 6350-SR/6355-SR device to bring up its Details page.
3. Select the Commands drop-down list at the top-right of the page.
Note
Select the Check Configuration menu option to update a device immediately.
Digi 6350-SR/6355-SR LTE Router User Guide
Using remote commands
25