Default Surelink Configuration - Digi 6350-SR User Manual

Welcome
6. Enable the syslog server.
If the syslog server is not enabled and set to syslog.accns.com, the device will be able to
connect to aView and receive configuration updates, but unless the aView configuration
updates set the syslog server, the device will not be able to send any metrics or logs to aView.
a. Click System > Log > Server list > Server.
b. Click Enable.
c. Verify that Server is set to syslog.accns.com.
d. (Optional) Select the event types to be sent to aView.
7. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Default SureLink configuration

With firmware version 20.2.x, Active Recovery has been renamed to SureLink. After upgrading from a
firmware version prior to 20.2.x to firmware version 20.2.x or greater, your existing Active Recovery
configuration will remain in place. The only change will be that the feature is renamed from Active
Recovery to SureLink.
However, if you erase the configuration of a device that was upgraded from a firmware version prior
to 20.2.x, it will use the default SureLink settings. The default SureLink settings are:
Interface
Default wireless WANs (Modem)
IPv4
IPv6
Default WANs
IPv4
IPv6
Digi 6350-SR/6355-SR LTE Router User Guide
Important information about upgrading to firmware version 20.2.x
Status
Enabled
Disabled
Enabled
Disabled
Action
Restart interface
Restart interface
13