About Aview; Viewing And Editing Group Configurations; Upgrading Firmware - Digi 6350-SR User Manual

Getting started with aView

About aView

The following actions are typically performed by your network administrator.
Changes can be made either at the device or group level. Select override from any given menu item to
edit its inherited value, or navigate to the SR's corresponding group configuration page to update the
config profile shared between all devices belonging to this group.
It is recommended that aView centrally manages the Digi 6350-SR/6355-SR devices; only resort to
local management as necessary. For any questions regarding how to access aView, please contact
Digi support or your purchasing partner.

Viewing and editing group configurations

To bring up a device in the configuration portal:
1. Use the search bar to filter devices by MAC address.
Note The device MAC address is on its bottom label.
2. Select the MAC address of your Digi 6350-SR/6355-SR device and bring up its Details page.
3. Navigate to the Configuration tab of the left-side menu.
4. Follow the Edit Group Configuration link.
5. Adjust the necessary settings, clicking the Update button to apply any changes.
Devices will automatically apply configuration updates after the next daily sync (1am UTC by default).
Refer to Using remote commands

Upgrading firmware

WARNING! When the Digi 6350-SR/6355-SR is updating firmware, its LEDs will flash red and
yellow. Do NOT remove power from the device during this process.
To view or select new firmware:
1. Navigate to the Configuration tab of the left-side menu.
2. Follow the Edit Group Configuration link.
3. Locate the Firmware pull-down menu.
4. Select on the intended version and wait for the settings to finish loading.
5. Click on the Update button at the bottom of the page to confirm firmware selection.
Digi 6350-SR/6355-SR LTE Router User Guide
for details on how to apply changes sooner.
About aView
24