Digi 6350-SR User Manual page 14

Welcome
If the device is configured to synch with aView, it should get the correct SureLink configuration from
aView. If not, you can configure SureLink by using the local WebUI:
1. Log into the Digi 6350-SR/6355-SR WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click to expand a WAN or WWAN (Modem).
5. After creating or selecting the WAN or WWAN, click IPv4 (or IPv6) > SureLink.
6. Make any necessary configuration changes.
7. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
Digi 6350-SR/6355-SR LTE Router User Guide
Important information about upgrading to firmware version 20.2.x
14