Toleranceerror; Wirestuck; Gatedooropen; Panellocked - Kemppi A7 350 Integration Manual

6.2.25 ToleranceError

This signal function is a common indicator for the tolerance
status signals CurrentOk and WFSpeedOk. If one of the
values is outside its tolerances, this signal is set (1).
• 0 = Values within tolerances
• 1 = At least one of the values outside the
tolerances
This function is not implemented in the A7 MIG Welder.
The status is always OK (0).

6.2.26 WireStuck

This signal function indicates whether the wire is stuck in
the weld.
• 0 = Wire is OK.
• 1 = Wire is stuck.
This function is not implemented in the A7 MIG Welder.
The status is always OK (0).

6.2.27 GateDoorOpen

This signal function indicates whether the gate door is
open or closed. Opening the gate door always causes an
error (Error 134: Gate door
Some functions, such as the touch sensor and the wire
feed, can still be used.
• 0 = Gate door closed (OK)
• 1 = Gate door open (error)

6.2.28 PanelLocked

This signal function is deprecated. The status is always 0
(not locked).

6.2.29 LocalRemote

This signal function is deprecated. The status is always 1
(local).

6.2.30 AutoManual

This signal function is deprecated. The status is always 0
(manual).
50
© Kemppi Oy 2020
open) in the welding system.
A7 MIG Welder 2002