Introduction; Integration Step By Step - Kemppi A7 350 Integration Manual

1.

INTRODUCTION

The A7 MIG Welder is a complete welding system for automated welding applications.
This guide, together with the A7 MIG Welder operating
set up the system and perform the necessary cable connections and setup configuration
to get the system running.
Important notes
Items in the manual that require particular attention for minimizing damage and harm
are indicated with the symbols below. Read these sections carefully, and follow their
instructions.
Note: A note item gives the user a useful piece of information.
Caution: Caution items describe a situation that may result in damage to the equipment
or system.
Warning: Warnings describe a potentially dangerous situation. If not avoided, it will
result in personal harm or fatal injury.
Disclaimer
While every effort has been made to ensure that the information contained in this guide
is accurate and complete, no liability can be accepted for any errors or omissions. Kemppi
reserves the right to change the specification of the product described, at any time,
without advance notice. Do not copy, record, reproduce, or transmit the contents of this
guide without prior permission from Kemppi.
The web user interface server, part of the robot interface unit, is meant to be used only
in point-to-point connection with one authorized personal computer. For the sake
of confidentiality, it is not recommended to connect the A7 MIG Welder system to any
public or internal network. Kemppi is not liable for errors or damage resulting from non-
compliance with this recommendation.
manual, instructs you on how to
© Kemppi Oy 2020
2.

INTEGRATION STEP BY STEP

To ensure safe and efficient integration of the welding system, follow these simple
steps:
1. INSTALL THE HARDWARE
• Make sure that all the components are OK.
• Mount the cooling unit, if any, on the power source.
• Attach all required equipment to the robot and to the
welding cell.
• Make all required cable connections.
• Power up the system.
2. ACCESS THE WEB USER INTERFACE
• Configure the network connection by means of the
setup panel.
• Open the web user interface using a web browser.
3. CONFIGURE THE SYSTEM
• Configure the welding system, sensors, and devices.
• Configure the digital robot interface.
• Configure system users.
• Create memory channels.
• Make a system backup.
After completion of these steps, the system is ready for welding.
For detailed instructions on each step, consult the corresponding section of this
document.
4
A7 MIG Welder 2002