Table of Contents
Advertisement
5.
SYSTEM CONFIGURATION
This section describes the settings that are typically
made only once or that are otherwise necessary for
integration to be completed successfully. It does not
describe those settings that affect welding quality and are
modified on the basis of the welding operation. For more
information on the operation-based settings, see the
MIG Welder operating
manual.
Use the web user interface to perform the system
configuration within the integration. Some items necessary
for the integration phase, such as fieldbus configuration
parameters, are not available from the setup panel.
5.1 Welding system, sensors and devices
To configure the welding system, go to the
settings > Welding
system.
5.1.1 General settings
Water cooling
Set the water cooling in accordance with your system
A7
configuration:
• Choose
OFF
for a gas-cooled system
• Choose
ON
for filling up the cooling system
• Choose
AUTO
for normal operation with a water-
cooled system
Welding cable length
Set the welding cable length in meters. The cable length
includes the welding (-) and welding (+) cables.
Welding
Example:
Welding (-) clamp cable length
Interconnection cable set length
Torch cable set length
Total welding cable length
© Kemppi Oy 2020
5.1.2 Wire feed settings
Wire feeder
Select the wire feeder you are using. This setting has effect
only in systems with dual wire feeder support:
installed. That kit is available separately and is not included
in the standard package.
10 m
Wire feed motor current warning level
10 m
Set the wire feeder motor warning level to match the
2 m
wire liner length, wire diameter, and other parameters
affecting the load on the wire feeder motors. The initial
22 m
value is 3.5 A. The system issues a warning when the long-
term average current exceeds the warning threshold.
22
A7 MIG Welder
• Choose
WIRE FEEDER 1
for the primary wire
feeder
• Choose
WIRE FEEDER 2
for the secondary wire
feeder
• Choose
SELECT AT ROBOT
to manage the wire
feeder selection from the robot pendant.
This feature requires the dual wire feeder extension kit
2002
Hide quick links:
Advertisement
Table of Contents
