Table of Contents
Advertisement
Open, and then remove the drive bay cover.
b.
Remove the drive.
2.
Replacing the solid-state device
Process overview:
Prepare the server for hardware replacement (on page 20).
1.
Remove the solid-state device (on page 39).
2.
To replace the solid-state device, reverse the removal procedure.
3.
Prepare the server for operation (on page 28).
4.
Remove the solid-state device
Before you perform this procedure, make sure that you have the following tools available:
•
No. 1 Phillips screwdriver (for the solid-state device screw)
•
No. 2 Phillips screwdriver (for the M.2 SSD compartment cover screw)
To remove the component:
Remove the M.2 SSD compartment cover:
1.
Loosen the captive screw.
a.
Removal and replacement procedures 39
Advertisement
Table of Contents
