Table of Contents
Advertisement
Remove the drive from the carrier.
2.
Replacing the drive SATA-power Y-cable
Process overview:
Prepare the server for hardware replacement (on page 20).
1.
Remove the access panel (on page 23).
2.
If installed, remove the communication board (on page 23).
3.
Remove the server drive assemblies (on page 25).
4.
Remove the drive SATA-power Y-cable (on page 42).
5.
To replace the drive SATA-power Y-cable, reverse the removal procedure.
6.
Prepare the server for operation (on page 28).
7.
Remove the drive SATA-power Y-cable
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Remove the cable clip screw.
1.
Remove the drive power cable clip.
2.
Disconnect the drive power cable.
3.
Removal and replacement procedures 42
Advertisement
Table of Contents
