Table of Contents
Advertisement
Prepare the server for operation (on page 28).
6.
Remove the system battery
Before you perform this procedure, make sure that you have a small flat-nose plier available.
Locate the battery on the system board
1.
Slightly push the metal tab, and then use the small flat-nose pliers to remove the system battery from
2.
its socket.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
Replacing the ambient temperature sensor cable
Process overview:
Prepare the server for hardware replacement (on page 20).
1.
Remove the access panel (on page 23).
2.
If installed, remove the communication board (on page 23).
3.
Remove the server drive 2 assembly
4.
Remove the ambient temperature sensor cable (on page 46).
5.
To replace the ambient temperature sensor cable, reverse the removal procedure.
6.
Prepare the server for operation (on page 28).
7.
Remove the ambient temperature sensor cable
Disconnect the ambient temperature sensor cable from the system board.
1.
("System board
components" on page 56).
("Remove the server drive
Removal and replacement procedures 46
assemblies" on page 25).
Advertisement
Table of Contents
