Table of Contents
Advertisement
Tilt the server down until the two posts on top of the storage expansion unit seat into the
2.
corresponding openings on the bottom of the server.
This docking action attaches the server to the storage expansion unit. However, the assembly is
NOT yet locked into place.
Hold the top side of the server and the bottom side of the storage expansion unit, and then carefully
3.
turn the assembly over to access the bottom side of the storage expansion unit.
Pull the latch on the rear of the storage expansion unit.
4.
Tighten the captive screws.
5.
Push the latch back in place.
6.
Return the assembly to an upright position.
7.
Power up procedure
Power up a single-server system
Press the Power On/Standby button.
1.
Removal and replacement procedures 37
Advertisement
Table of Contents
