Table of Contents
Advertisement
Remove the DIMM.
2.
Replacing the communication board
Process overview:
Prepare the server for hardware replacement (on page 20).
1.
Remove the access panel (on page 23).
2.
Remove the communication board (on page 23).
3.
Install the communication board spare
4.
Prepare the server for operation (on page 28).
5.
Replacing a server drive
Process overview:
Prepare the server for hardware replacement (on page 20).
1.
Remove the access panel (on page 23).
2.
If installed, remove the communication board (on page 23).
3.
Remove the server drive assemblies (on page 25).
4.
Remove the drive from the carrier (on page 41).
5.
To replace the drive, reverse the removal procedure.
6.
Prepare the server for operation (on page 28).
7.
Remove the drive from the carrier
Before you perform this procedure, make sure that you have a No. 2 Phillips screwdriver available.
Remove the drive screws.
1.
("Install the communication
Removal and replacement procedures 41
board" on page 32).
Advertisement
Table of Contents
