Table of Contents
Advertisement
If removed, install the server drive assemblies (on page 30).
b.
If removed, install the communication board (on page 32).
c.
If removed, install the access panel (on page 34).
d.
If the server was removed from the cradle, wall mount, or storage expansion unit:
2.
Install the server in the cradle (on page 34).
o
Install the server in the wall mount (on page 35).
o
Install the server on the storage expansion unit (on page 36).
o
If removed, install the Kensington security lock.
3.
For more information, see the Kensington security lock documentation.
Connect all peripheral cables to the server.
4.
Connect the power adapter to the server, and then connect the power cord to the AC source.
5.
Secure the power cord and rear panel cables based on the standard cable management practices.
6.
Do one of the following:
7.
Power up a single-server system (on page 37).
o
Power up a clustered system (on page 38).
o
Install the middle frame
Before you perform this procedure, make sure that you have the following tools available:
•
T-15 Torx screwdriver
•
Flathead screwdriver
To install the component:
Align the middle frame with the system board.
1.
Removal and replacement procedures 29
Advertisement
Table of Contents
