Engine Reassembly; Install Seal; Install Cam Bracket Assembly - Toro AC-1 Service Manual

ENGINE REASSEMBLY
Install Seal
1.
I f
the seal was removed in Part
3
-
Disassembly,
press a new seal into the crankcase until it is
flush with the crankcase surface (with the
metal surface facing out).
NOTE: To make the installation of the seal easier,
grease the inner ring of the seal with
Mobilgrease (R) HP or an equivalent.
Install Cam Bracket Assembly
1.
Rotate the crankshaft until the crankpin is at top
5
dead center between the timing marks
2. Slide the cam bracket assembly into the
crankcase with the open hole of the cam gear
down (6 o'clock) and the blocked hole at the top
(1 2 o'clock).
5-4
I
2.6047.109
2.6047.109
2.6047.110