Install Fan Housing; Install Fuel Tank And Fuel Tank Bracket; Install Starter Module Assembly - Toro AC-1 Service Manual

ENGINE ASSEMBLY (cont.)
Install Fan Housing
1. Install the fan housing with the four (4) screws to
the crankcase.
Torque the fan housing screws to 40-45 in-lb
(4.5-5.0 N.m).
-
Install Fuel Tank And Fuel Tank Bracket-
1. Install the rubber fuel tank pad to the fuel tank.
2. Install the fuel tank and fuel tank bracket with t
two
(2) screws.
Torque the screws to 25-35 in-lb (2.8-3.3 N.m).
-
Install Starter Module Assembly
1. Place the starter module over the crankshaft.
2. Install the starter rope eyelet bracket with the two
(2) screws.
Torque the screws to 15-20 in-lb (2.0-2.5 N-m).
NOTE: It may be necessary to pull the starter rope
slightly to enable the starter housing to drop into
sition.
5-1 5