Toro AC-1 Service Manual page 42

I
REMOVE MAJOR COMPONENTS
(cont.)
3.
With the starter pawls on the flywheel positioned
at the top (12 o'clock) and bottom (6 o'clock), in-
stall flywheel holding tool, P/N 18091 9.
4. Lift the starter assembly until
it
contacts the clutch
rotor. At 9 o'clock on the fan housing, roll the fly-
wheel holding tool into the flywheel until the
head of the cap screw on the bottom of the tool
fits into the screw hole of the fan housing.
5. Holding the flywheel holding tool in place, postion
the clutch rotor tool (P/N 180918) over the rotor.