Remove Piston/Connecting Rod - Toro AC-1 Service Manual

I
I
4. Remove the two (2) cylinder screws from the
cylinder.
DISASSEMBLE ENGINE (cont.)
L
2.6047.065
5. Remove the cylinder and cylinder gasket from the
crankcase.
NOTE: Do not scrape the gasket from the cylinder.
To remove the gasket, soak the cylinder with solvent.
Remove
Piston/connecting
rod
1. Remove the piston/connecting rod from the crank-
case. Grasp the piston/connecting rod, slide it to
the rear and twist slightly. No tool is required.
3-1 8
2.6047.066