Install Cylinder - Toro AC-1 Service Manual

ENGINE ASSEMBLY (cont)
2. Orient the ring gaps as shown
r-
.
RING GAP ORIENTATION
Top
Ring
45 Deg. CCW
To Pin
Bottom Ring
90 Deg. CCW
To Top Ring
Middle Ring
180 Deg.
CCW To Top
Ring
I
Wrist Pin Axis
I
3.6047.102
3.
Install the piston/connecting rod assembly into
the crankcase with the lettering on the bearing
of the connecting rod facing the crankshaft
counterweight. Slide
it
down in the crankcase.
Angle it slightly and roll it into place. Be sure
not to dislodge the wrist pin buttons.
2.6047.113
Install
Cylinder
1.
Install the cylinder to crankcase gasket. Always
use a new gasket. While holding the piston/con-
necting rod in place, slide the cylinder into the
crankcase.
NOTE: Hold the wrist pin buttons in place as
you install the cylinder.
5-6