Remove Fuel Tank Bracket And Fuel Tank; Fuel Tank And Lines Disassembly And Reassembly; Fuel Line And Filter Removal; Fuel Line And Filter Installation - Toro AC-1 Service Manual

REMOVE MAJOR COMPONENTS
(cont.)
Remove Fuel Tank Bracket And Fuel Tank
'
1. Remove the two (2) screws from the fuel tank
bracket.
2. Remove the fuel tank bracket and fuel tank.
3. Remove the rubber fuel tank pad.
3
Fuel Tank And Lines Disassembly And
Reassembly
Fuel Line and Filter Removal
This unit has two fuel lines to the fuel tank. The
clear line provides normal fuel flow. The blue line
provides a return line for excess fuel flow during th
primer operation.
1.
Push the fuel line into the fuel tank until you can
2. If the fuel filter is dirty or clogged, replace it with a
pull the filter out of the tank neck.
new fuel line assembly.
Fuel Line and Filter Installation
1. Insert a piece of trimmer line through the hole in
the rear side of the fuel tank to the filler opening.
Slide the fuel line over the trimmer line.
2. Guide the fuel line through the hole in the tank
with the trimmer line.
3. Working through the filler neck, insert the fuel line
with the fuel filter attached through the hole in
the rear of the tank.
4.
Work the fuel line from outside of tank, pulling un
the filter lays on the bottom of the tank or
6
inches (1 52 mm) of line are exposed.
3-1 3