Remove Lower Handle - Toro AC-1 Service Manual

2. Separate the two halves of the handle by prying
the two halves apart with a screwdriver at the
rear of the handle, next to the screw boss
.
NOTE: The anti-vibration isolator is wedged into the
handle, making removal of the halves difficult.
E
2.6047.026
Remove Lower Handle
-
1. Remove the retainer screw, which holds the
switch and throttle trigger assembly in the han-
dle. The trigger can now be removed from the
cable and the switch lifted off the two pins lo-
cated in the lower handle.
2. Remove the throttle cable and lead wires from
the lower handle.
I
REMOVE MAJOR COMPONENTS
(cont.)
I
3
3
3.
Press down on the lower handle at the rear, near
the isolator. This will dislodge the isolator from
the lower handle, allowing the handle to be re-
.
moved.
I
NOTE: If you have difficulty removing the lower
handle slightly loosen the screws on the fuel tank
bracket and pull the fuel tank and bracket away from
the lower handle.
NOTE: When removing the lower handle note
the location of the anti-rotation cap screw, lead wires
and throttle cable location.
3-5