Breather Disassembly And Reassembly - Toro AC-1 Service Manual

STARTER DISASSEMBLY AND,
REASSEMBLY (cont.)
8. Install the pulley/rope assembly into the starter
housing. Rotate the pulley slightly until the spring
hooks onto the pulley and the-pulley drops 'into
place.
9. Holding the pulley down, put 1 full turn of Spring
tension on the pulley.
10. Install the two (2) pulley retainers and screws.
Torque the screws to 20-30 in-lb (2.3-3.4 N-m)
I
11. Pull the rope out to its full length and
let
it
return. Check the spring tension and adjust
as necessary. Refer to "Adding Starter Spring
Tension" on page
4-1 0
for the location of the
starter rope.
2.6047.086
"
Breather Hose
Plug
"
Breather Hose
BREATHER DISASSEMBLY AND
REASSEMBLY
1.
.
Remove the breather hose assembly from the
rocker arm cover.
2 Remove the breather hose from the breather
housing/plug.
4-1 5