Install Ignition Module - Toro AC-1 Service Manual

ENGINE ASSEMBLY (CONT.)
WARNING: CRACKED OR BROKEN COOLING
FINS ARE A HAZARD! Be careful not to crack
or break any cooling fins. They could fly off
during operation. If cooling fins are cracked or
broken, replace the flywheel.
1.
Install the flywheel key into the keyway on the
2. Position the flywheel so that the key slot in the
crankshaft.
flywheel aligns with crankshaft key. Place the fly-
wheel onto the crankshaft.
3.
Install the flywheel spacer and clutch rotor to hold
the flywheel in place.
Install Ignition Module
1. Install the ignition module ground lead tab
terminal and module fastening screws.
2.
Move the ignition module away from the flywheel
as far as possible. Tighten the fastening screws
slightly.
J
I27
2.6047.128
3.
4.
5.
Insert a 0.008-0.012 in (0.201-0.305
mm)
feeler
gauge or shim stock between the ignition mod-
ule and the flywheel magnet surfaces.
Loosen the module fastening screws and push the
ignition module tight against the feeler gauge or
shim shock.
Torque the screws to 30-40 in-lb (3.3-4.5 N.m).
Connect the switch lead wires as necessary. Re-
move the clutch rotor.
2.6047.129
5-1 4