Carburetor Reassembly; Fuel Metering Side - Toro AC-1 Service Manual

CARBURETOR DISASSEMBLY AND
REASSEMBLY (cont.)
Refer to the appropriate parts manual for service kit part
numbers.
1. Inspect the tips of the high speed mixture needle,
idle speed mixture needle, and fuel inlet needle
for wear or damage. Replace the needles if nec-
essary.
4
2. Gaskets and diaphragms eventually deteriorate
and become stiff with age and use.
It
is good
practice to replace gaskets and diaphragms for
each repair. However, if the diaphragm is soft
and flexible, you do not need to replace it, un-
less a complete carburetor rebuild is being per-
formed.
3.
Clean the metering cover, pump cover, carburetor
body and filter screen with carburetor cleaner.
Blow out all passages with compressed air.
Carburetor Reassembly
Fuel Metering Side
1. Install the fuel inlet needle, fuel metering lever
spring, metering lever and metering lever hinge
pin. Secure the hinge pin in carburetor body with
the hinge pin screw.
4-6
Inspect Here
I I
1
2.6047.078