Starting/Stopping Instructions; To Start The Engine - Toro AC-1 Service Manual

STARTING/STOPPING
INSTRUCTIONS
To Start the Engine
1. Set the unit on the ground, check the oil level in the
oil pan, and put the ignition switch in the "RUN" (I)
position (Figure 1-8).
Figure 1-8. Ignition Switch and Throttle Trigger.
3.6051.008
2. FULLY PRESS AND RELEASE the primer bulb 5 to
7 times (Figure 1-9).
NOTE: For a warm engine, go directly to step 5
(place the choke lever directly in the "PARTIAL" choke
position).
3.
Place the choke lever in the FULL "CHOKE" posi-
tion (Figure 1-9).
---Run position
choke
Partial Choke
Figure 1-9. Primer Bulb, Choke Lever and Choke
,
Positions.
3.6051.009
4. With the unit on the ground, pull the starter rope
quickly until the engine sounds like it wants to run
(no more than 5 pulls) (Fig. 1-10).
Figure 1-1
0 .
Pulling the Starter Rope.
3.6051.010
1-10