Starter Disassembly - Toro AC-1 Service Manual

STARTER DISASSEMBLY AND
REASSEMBLY (cont.)
I
2.8047.088
Starter Pulley
Retainer
Retainer Screw
Starter Disassembly
1.
Relieve the spring tension by removing the' pull
handle and allowing the pulley to slow/y unwind
inside the starter pulley. Make sure the spring
tension is fully relieved before proceeding.
2. Remove the two (2) screws and retainers.
3.
Remove the starter pulley from the starter
housing.
4. If necessary, remove the starter spring from the
starter housing.
NOTE: To prevent injury when removing the
starter spring, drop the spring into a trash container,
which will release the spring from the housing.
NOTE: Once the starter spring is removed from
the starter housing, a service replacement spring
(prewound and contained in a spring retainer)
should be used to reassemble the starter. Reinstalla-
tion of the old starter spring is not recommended.