Install The Pressure Transducer - Raven SmarTrax Installation Manual

Chapter 3
Left and Right Steering Hoses Installed
FIGURE 11.
Machine's Left
Steering Hose
Machine's Right
Steering Hose
Install a 12L, M18 x 1.5 M/M/F swivel run tee adapter fitting (P/N 333-0012-356) in port L of the steering
7.
orbital.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-861) on the 90° end of the installed tee
8.
fitting.
Connect the 45° end of the installed hydraulic hose to the fittings installed in Port A of the SmarTrax valve.
9.
Connect the machine's left steering hose to the remaining end of the installed tee fitting.
10.
Note:
It may be necessary to install the hose guard and cable ties (P/N 214-3000-001) on the left
steering hose to prevent damage.

Install the Pressure Transducer

Steering Orbital Configuration Options
FIGURE 12.
Load Sense Steering Orbital
The method of installing the pressure transducer (P/N 422-0000-086) depends on the type of steering orbital
present on the machine. Refer to Figure 11 above to determine the machine's steering orbital configuration.
•
If a hose is installed on the left side of the steering orbital, it is classified as a load sense steering orbital.
Refer to Load Sense Steering Orbital below to install the pressure transducer.
20
AGCO RT-A Series, Massey Ferguson 64XX/74XX/76XX Series, Challenger MT5X5B Series SmarTrax™ Installation Manual
Installed Hose (P/N
214-1000-861)
Hose Guard
Open Center Steering Orbital