Raven SmarTrax Installation Manual page 29

Install a -6 JIC (M) to -6 SAE O-ring (M) straight adapter fitting (P/N 333-0012-045) on the remaining
b.
end of the shuttle valve.
Install the -6 JIC 5 PSI check valve (P/N 334-0003-078) on the end of the installed adapter fitting.
c.
Load Sense Hose Installed
FIGURE 19.
Install the shuttle valve assembly on the fitting installed in Port LSPV of the SmarTrax valve (P/N 334-0003-
2.
088).
Locate the load sense (LS) port on the hydraulic valve at the rear of the machine.
3.
Remove the existing cap from port LS.
4.
Install the 90° end of the supplied hydraulic hose (P/N 214-1000-862) in port LS of the hydraulic valve.
5.
Connect the straight end of the installed hydraulic hose to the shuttle valve assembly installed in Port LSPV
6.
of the SmarTrax valve.
Note:
If the machine is equipped with an attachment that utilizes load sense, the load sense hose from
the attachment must be connected to the top port of the shuttle valve assembly in which the -6
SAE O-ring (M) plug is installed. The hydraulic fitting used to achieve this connection is not
supplied.
Manual No. 016-5033-006 Rev. B
Hydraulic System Installation
25