Raven SmarTrax Installation Manual page 43

Install the mating 12-pin connector of the 12-pin Deutsch adapter cable (P/N 115-4001-219) on the 12-pin
2.
connector of the valve harness.
Connect the remaining 12-pin connector on the 12-pin Deutsch adapter cable to the mating connector of
3.
the node harness (P/N 115-4001-126).
VALVE Harness Connection
FIGURE 7.
Connect the VALVE connector to the open 4-pin port of the SmarTrax valve (P/N 334-0003-088).
4.
TRANSDUCER Valve Harness Connection
FIGURE 8.
Load Sense Steering Orbital
Route the TRANSDUCER connector to the installed transducer assembly and connect it to the pressure
5.
transducer (P/N 422-0000-086) as shown in the figure above.
Manual No. 016-5033-006 Rev. B
Cab Component Installation
Open Center Steering Orbital
39