Table of Contents
Advertisement
Chapter 3
SmarTrax Valve Installed on Mounting Plate
FIGURE 4.
Mount the SmarTrax valve (P/N 334-0003-088) to the hydraulic valve mounting bracket (P/N 107-0171-705)
2.
using four 5/16" hex bolts (P/N 311-0052-104) and four 5/16" lock washers (P/N 313-1000-019).
Mount the flow switch (P/N 334-0003-085) to the valve mounting bracket using two 1/4"-20 x 2" screws (P/N
3.
311-0050-109), two 1/4" flat washers (P/N 313-2300-009), two 1/4" split lock washers (P/N 313-1000-016),
and two 1/4"-20 hex nuts (P/N 312-1001-074).
SmarTrax Valve Mounted on the Machine
FIGURE 5.
Mount the hydraulic valve mounting bracket (P/N 107-0171-705) to the machine's radar bracket using the
4.
bolts removed in step 1.
Install the Pressure Hose
Locate the machine's steel pressure line.
1.
Note:
The pressure line runs on the inside of the frame from the rear of the machine. The line bends 45°
just before the hydraulic hose connection. Trace it to the P port on the steering orbital if necessary.
Disconnect the machine's pressure hose from the steel pressure line.
2.
12
Case IH SPX 3230, 3320, and 3330 SmarTrax™ Installation Manual
Advertisement
Table of Contents
