Load Sense Steering Orbital - Raven SmarTrax Installation Manual

•
If a load sense hose is not installed on the left side of the steering orbital, the steering orbital is classified as
an open center steering orbital. Refer to Open Center Steering Orbital section on page 23 to install the
pressure transducer.

Load Sense Steering Orbital

Pressure Transducer Assembly
FIGURE 13.
P/N 333-0012-354
P/N 214-1000-864
Install the -4 NPT (M) to -4 SAE O-Ring (F) straight adapter fitting (P/N 333-0012-354) in the female NPT
1.
branch of the -4 JIC (M) x -4 NPT (F) x -4 JIC (M) branch tee adapter fitting (P/N 333-0012-353).
Note:
Use thread sealer on the connection to prevent leakage.
Install the 0-3000 PSI pressure transducer (P/N 422-0000-086) on the end of the installed adapter fitting.
2.
Install the female JIC ends of the supplied hydraulic hoses (P/N 214-1000-863) on the male ends of the
3.
branch fitting.
Manual No. 016-5033-006 Rev. B
Hydraulic System Installation
P/N 422-0000-086
P/N 333-0012-353
P/N 214-1000-863
21