Raven SmarTrax Installation Manual page 34

Chapter 4
WAS Installed on Mounting Bracket
FIGURE 2.
Mount the rotary WAS (P/N 063-0131-024) to the appropriate mounting bracket using the hardware
2.
supplied in the WAS package.
Note:
Install the sensor so that the cable points down when mounted on the axle.
WAS Assembly Alignment
FIGURE 3.
Flat Side of
Shaft
Cable Exit
Point
Align the flat side of the shaft with the cable exit point as shown in the figure above.
3.
WAS Linkage Rod Assembly
FIGURE 4.
Install the M10 jam nut (P/N 312-1001-035) and M10 stud linear sensor mount (P/N 103-0001-030) on one
4.
end of the WAS linkage rod (P/N 107-0172-125).
Note:
Do not fully tighten the nut.
30
AGCO RT-A Series, Massey Ferguson 64XX/74XX/76XX Series, Challenger MT5X5B Series SmarTrax™ Installation Manual