Install The Pressure Hose - Raven Case IH Patriot 3XX0 Guidance And Steering Installation Manual

C 3
HAPTER
FIGURE 4. Steering Valve Installed on Mounting Plate
2. Mount the steering valve (P/N 334-0003-088) to the hydraulic valve mounting bracket (P/N 107-0171-705)
using four 5/16" hex bolts (P/N 311-0052-104) and four 5/16" lock washers (P/N 313-1000-019).
3. Mount the dual transducer hydraulic manifold (P/N 334-0003-085) to the valve mounting bracket using two
1/4"-20 x 2" screws (P/N 311-0050-109), two 1/4" flat washers (P/N 313-2300-009), two 1/4" split lock washers
(P/N 313-1000-016), and two 1/4"-20 hex nuts (P/N 312-1001-074).
FIGURE 5. Steering Valve Mounted on the Machine
4. Mount the hydraulic valve mounting bracket (P/N 107-0171-705) to the machine's radar bracket using the bolts
removed in step 1.

INSTALL THE PRESSURE HOSE

1. Locate the machine's steel pressure line.
NOTE: The pressure line runs on the inside of the frame from the rear of the machine. The line bends 45° just
before the hydraulic hose connection. Trace it to the P port on the steering orbital if necessary.
2. Disconnect the machine's pressure hose from the steel pressure line.
14
Case IH Patriot 3XX0, Model Year 2010-2016 RS1™ HDU Guidance and Steering Installation Manual