Raven SmarTrax Installation Manual page 36

Chapter 4
Potential Interference Points
FIGURE 6.
Potential
Interference
Points
Determine which WAS arm bracket is suitable for use based on the machine's configuration.
3.
Note:
Unless the machine interferes with the WAS operation, the 5" arm bracket (P/N 116-0159-721)
should be used. Interference requires the use of the 4" arm bracket (P/N 116-0159-722).
Install the arm bracket on the WAS shaft and insert a 1/4"-20 knurled cup hex socket head set screw (P/N
4.
311-0015-729) through the hole in the arm bracket, tightening it against the flat spot on the sensor shaft.
Ball End of WAS Linkage Rod Installed
FIGURE 7.
Remove the nuts and clamp from the U-bolt muffler clamp (P/N 435-3003-053) and install the U-bolt around
5.
the right tie rod.
Note:
Discard the nuts from the muffler clamp. They are not used in the system installation.
Install the clamp on the ends of the U-bolt.
6.
Install one 3/8"-16 nylon insert lock nut (P/N 312-4000-061) on the top leg of the U-bolt as shown in the
7.
figure above.
Note:
Do not fully tighten the nut.
Install the ball end of the WAS linkage rod assembly on the bottom leg of the U-bolt.
8.
Secure the WAS linkage rod assembly to the U-bolt using one 3/8"-16 nylon insert lock nut (P/N 312-4000-
9.
061) and 3/8" flat washers (P/N 313-2300-013) as needed.
Note:
Do not fully tighten the nut.
32
AGCO RT-A Series, Massey Ferguson 64XX/74XX/76XX Series, Challenger MT5X5B Series SmarTrax™ Installation Manual