Open Center Steering Orbital - Raven SmarTrax Installation Manual

Open Center Steering Orbital

Pressure Transducer Assembly
FIGURE 15.
P/N 333-0012-311
P/N 333-0012-361
Install the female end of the 15L, M22 x 1.5 (F) to -6 JIC (M) straight adapter fitting (P/N 333-0012-378) on
1.
the 90° end of the 15L, M22 x 1.5 M/M/F swivel run tee adapter fitting (P/N 333-0012-361).
Install the -6 JIC (F) end of the -4 NPT (F) to -6 JIC (F) straight adapter fitting (P/N 333-0012-311) on the
2.
opposite end of the installed adapter fitting.
Install the -4 NPT (M) end of the -4 SAE O-ring (F) to -4 NPT (M) straight adapter fitting (P/N 333-0012-354)
3.
on the installed adapter fitting.
Note:
Use thread sealer on this connection to prevent leakage.
Install the pressure transducer (P/N 422-0000-086) on the -4 SAE O-ring (F) end of the installed adapter
4.
fitting.
Machine's Priority Valve
FIGURE 16.
Locate the priority valve at the rear of the machine, in front of the hydraulic valve.
5.
Manual No. 016-5033-006 Rev. B
Hydraulic System Installation
P/N 422-0000-086
P/N 333-0012-354
P/N 333-0012-378
23