Table of Contents
Advertisement
9.1.2.8
Store Actual Parameters (STORE_PI)
With this call, the configured parameters stored on the EEPROM are overwritten
with the current, permanently stored (actual) parameters; in other words, the pa-
rameters of all the AS-i slaves are configured.
byte
1
2
byte
1
2
9.1.2.9
Set Permanent Configuration (SET_PCD)
This call sets the following configuration data for the addressed AS-i slave:
• I/O configuration
• ID code
• Extended ID1 code
• Extended ID2 code
The configuration data are stored permanently on the EEPROM of the AS-i/
CC-Link Gateway and are used as the expected configuration by the AS-i master
in the protected mode. The configuration data are specified by the manufacturer
of the AS-i slave.
If the addressed AS-i slave does not support an extended ID code 1/2, the value
F
must be specified.
hex
When this command is executed, the AS-i master changes to the offline phase and
then changes back to the normal mode (warm restart on the AS-i master).
This command can only be executed in the configuration mode.
byte
1
2
3
4
5
Subject to reasonable modifications due to technical advances.
38
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
7
6
5
2
2
2
T
–
7
6
5
2
2
2
T
7
6
5
2
2
2
T
–
–
B
xID2
ID
Request
4
3
2
2
04
16
circuit
Response
4
3
2
2
04
16
result
Request
4
3
2
2
25
16
circuit
slave address
AS-Interface
Mailbox
2
1
0
2
2
2
2
1
0
2
2
2
2
1
0
2
2
2
xID1
I0
Copyright Pepperl+Fuchs, Printed in Germany
Advertisement
Table of Contents
