Blackmagicdesign ATEM Live Installation And Operation Manual page 89

Once you have selected a HyperDeck, rotate the knob under the 'input' indicator to select
which input that HyperDeck is connected to on your switcher. For example, if HyperDeck 1 is
connected to SDI In 4 on your switcher, rotate the knob under the 'input' indicator to select
'camera 4.' Press the 'input' knob to confirm your selection.
Repeat this process for any additional HyperDecks you have connected to your switcher by
assigning inputs to HyperDeck slots 1, 2, 3 and 4, if required.
Assigning an IP Address
Once you've assigned an input to a HyperDeck, you'll need to enter its IP address. This allows
ATEM Advanced Panel to control the HyperDeck via Ethernet.
To enter a HyperDeck's IP address, navigate to the third HyperDeck settings page with the 'left'
or 'right' arrow buttons, or pressing '3' on the numeric keypad while in the HyperDeck
settings menu.
In this page, you'll see an IP address for the currently selected HyperDeck. Each IP address
number corresponds to a rotary knob below it. To change these numbers, you can rotate the
corresponding knob, or press the knob once and enter a number using the numeric keypad.
Do this for each number in the IP address.
Once you've entered the IP address for your HyperDeck, press the soft button corresponding
to the 'save changes' indicator to confirm the address. To cancel, press 'undo'.
To enter the IP address for subsequent HyperDecks, you'll need to select the HyperDeck using
the first page of the HyperDeck settings menu.
HyperDeck Control 89