Blackmagicdesign ATEM Live Installation And Operation Manual page 177

Production switchers
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Recall All
When this feature is enabled, you can recall a stored scene file on all cameras simultaneously
when you press the corresponding scene file button on a single CCU.
For example, you may have a specific setup for each camera that is optimized for a set in your
live production. This will likely be a large number of settings that you will want to recall later
when you return to that set.
The following is an example of how you can recall complex settings for multiple cameras
simultaneously.
To recall a scene file to multiple cameras:
1
Once all your cameras are set up, store a scene file for each camera on scene file 1.
2
Enable the 'recall all' setting by pressing the corresponding soft button in the LCD
home menu.
3
Now make any changes you want to each camera.
4
Press the scene file 1 button on any CCU. You will notice that all CCUs have recalled the
settings stored in scene file 1 for each independent CCU.
NOTE
While this feature is very powerful and helpful, please use with care as it affects
all cameras, including the camera switched to the program output. We recommend
enabling 'recall all' for specific setups prior to air and then immediately disabling the
feature until you need it again.
ND
This setting will be enabled in a future update.
CC
This setting will be enabled in a future update.
Master Gain
Blackmagic Design cameras have ISO and gain settings that can be set using the master gain
buttons on the camera control panel. To increase the master gain, press the up arrow next to
the master gain indicator. To decrease gain, press the down arrow.
Increasing or decreasing the master gain lets you allow for more light in dimly lit shooting
conditions, however it's worth being careful with the master gain as electronic noise can appear
in the image as it reaches its highest settings.
TIP
When a negative gain value is set, the down arrow will illuminate. When positive
gain is set, the up arrow will illuminate.
Using ATEM Camera Control Panel
177

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents