Blackmagicdesign ATEM Live Installation And Operation Manual page 128

4 Perform the transition as an auto transition or manual transition from the transition
control block.
DVE Transition Settings
To perform a DVE transition on an ATEM advanced panel:
1 On the preview bus, select the video source that you want on the program output.
2 Press the DVE transition type button to select the DVE transition. The DVE settings will
appear on the LCD menu.
NOTE If the DVE is already being used in an upstream key, the DVE transition
type will not be available for selection until the key is taken off air and off next
transition. Refer to 'sharing DVE resources' later in this section for
more information.
3 In the DVE LCD menu, use the soft control knobs and buttons to configure the DVE
parameters. For example, select the DVE pattern, movement, direction and adjust the
DVE transition rate.
4 Perform the transition as an auto or manual transition using the auto button or fader bar.
Operating your ATEM Switcher 128