Blackmagicdesign ATEM Live Installation And Operation Manual page 122

Dip Source Menu
To perform a dip transition on an ATEM advanced panel:
1 On the preview bus, select the video source that you want on the program output.
2 Press the DIP button to select the dip transition type. The LCD menu will automatically
display the transition settings.
3 Under the LCD use the control knob to adjust the dip rate. You can also enter a rate
duration using the number pad.
4 Use the corresponding control knob to select the dip source. You can also use the
select bus to select a dip source.
5 Perform the transition as an auto transition or manual transition from the transition
control block.
Press the 'dip' button in the transition control block, then set the dip source
and transition rate using the LCD menu and control knobs
Dip transition parameters
Rate The dip transition rate in seconds and frames.
Dip Source The dip source is any video signal in the switcher that will be used as the
intermediate picture for the dip transition, usually a color generator or media player.
Operating your ATEM Switcher 122